Inventory Checklist; Getting Started - IBM TotalStorage 200i Installation And User Manual

Inventory checklist

After you fully unpack your storage unit, verify that you have the following items:
v Hardware:
v Publications
If an item is missing or damaged, contact your IBM reseller or your IBM marketing
representative.
If you have not already done so, take a moment to review the information in this
chapter and record your storage unit serial number in the table in "Identification
numbers" on page 33. Then, return to this chapter to begin the installation process.

Getting started

Before you begin, review the following assumptions:
v If you are installing the storage unit in a rack, you have already installed the
v You have already installed and configured the host controllers and appropriate
v There are 68-pin VHDCI SCSI cables attached to the host controllers, ready for
v The installation site meets all area, environmental, power, and site requirements
10
IBM TotalStorage IP Storage 200i Storage Unit Installation and User's Guide
– 4125 IP Storage Model EXP
– Two or four power cords, depending on your country
– One 2 m (6.56 ft) SCSI cable
– One sheet of storage unit ID (0-9) labels
– One sheet of four SCSI ID labels
– One rack-mounting hardware kit
- Two rails (right and left assembly)
- Two M5 screws
- Ten M6 screws
- Ten M6 cage nuts
- Ten M6 clip nuts
– IBM TotalStorage IP Storage 200i Storage Unit Installation and User's Guide
(this book)
– IBM Safety book
– Template for installing the storage unit in a rack
other components in the rack and moved the rack to its permanent operating
location.
host adapters.
final connection to the storage unit.
for the storage unit. Refer to the storage unit requirements listed under
"Operating specifications" on page 9.