Changing The Password From The Library Manager - IBM TotalStorage 3494 Tape Library Operator's Manual

v If you want to return control to the remote Library Manager console or want to
Figure 277. Window List
Figure 278. Active Session

Changing the Password from the Library Manager

You can change the remote Library Manager console logon password only from the
Library Manager during a session. To change the password, perform the following
steps:
1. If you have an active session, take control at the Library Manager by pressing
430
3494 Tape Library Operator Guide
Attention: Do not close this window. If you CLOSE this window instead of
MINIMIZING it, remote console access to the Library Manager is disabled until
the Library Manager is rebooted.
allow the remote Library Manager console to monitor operations, change the
session state as follows:
– The remote Library Manager console operator can stop and restart the
connection at the remote Library Manager console.
– The Library Manager operator can restart the session as follows:
1. Press Ctrl + Esc to display the Window List.
2. On the Window List (Figure 277), select the DCAF Target \ Busy option
with the pointing device.
3. In the DCAF Target \ Busy window (Figure 278), select the Session
window, then select the Active or Monitor option.
Alt + T. The DCAF Target \ Busy window (Figure 279 on page 431) opens.