Table of Contents
Advertisement
|
|
|
|
|
|
|
|
|
Get VPD Summary
Send Get VPD requests for all selected devices.
Cancel Get VPD Summary
Cancels all active Get VPD Summary requests.
Copy Code from CD to Hard Drive
Invokes another panel to copy drive microcode files from a CD to the LM
PC hard drive C:\DRVIMGS.
Start Code Load
Loads the microcode (selected microcode filename) onto all the selected
devices.
Start Code Activate/Dev Reset
Activates a previously loaded microcode (selected microcode filename) at
all the selected devices.
Start Code Load/Activate
Loads the microcode (selected microcode filename) onto all the selected
devices and then activates the loaded microcode at the devices.
This applies only to the Code Load phase. If it is checked it forces the
Force
control unit or drive to load the microcode without regard to the current
levels in the control unit or drive.
Cancel Code Load/Activate
Cancels all active Loads, Activates, or Load/Activates.
Refresh
Refreshes the list of devices (although this list should NEVER change) and
the list of microcode files resident on the hard drive.
History
Display the history table entries.
Exit
Close the panel.
Help
Display help for this panel.
Verify Fix Diagnostics - 3592 (Service Representative)
The Verify Fix Diagnostics window is used to diagnose and fix problems related to
the 3592 drive and Library-Managed Encryption. Use this panel to test the paths to
the primary and alternate LME servers. This panel can only be accessed by IBM
service representatives.
The Devices list box, displayed in Figure 191 on page 304, lists all the 3592 drives
configured in the library. It also displays whether or not the device is selectable for
testing and the progress and results of any action taken. A device is considered
selectable for testing if it has been made UNAVAILABLE. Marking a device
unavailable is done by using the Service action bar.
Chapter 6. Advanced Operating Procedures
303
Advertisement
Table of Contents
