Hui Plug-In Control; Plug-In Editor; Plug-In Editor Display; Plug-In Editor Controls - Solid State Logic AWS DELTA 916 Owner's Manual

HUI P -
LUG IN

Plug-In Editor

AWS consoles come with a powerful Plug-in Editor located in
the console centre section. From here, plug-ins and hardware
inserts can be assigned, and plug-in parameters can be edited.
P -I E D
LUG N DITOR ISPLAY
The Plug-In Editor uses a high resolution TFT display, four V-
pots and four soft buttons to control the parameters of any
plug-in.
The display is also used to show the position and status of
the DAW and to provide access to a range of paged menus.
The currently selected
EDIT
top of the screen. Next are the plug-in control displays. Just
below this are the transport status displays and timecode
display.
The bottom section is used for soft key menu selection.
P -I E C
LUG N DITOR ONTROLS
The controls for the display are located just below the screen
area. The four V-pots and associated soft keys map to the
corresponding controls on the display. The V-pots also have
push-push select switches which perform various functions.
The display also shows information from the DAW at the top
of the editor display.
P B
AGING UTTONS
The left/right paging buttons page through either available
insert slots in
INSERT
mode (see following page).
PARAMETER
S DAW C
ELECTING
Select mode on the Master Control Panel then use the
EDIT
channel buttons to choose the channel you wish to edit.
SEL
The flag in the channel meter will light. The DAW will
EDIT
highlight the selected channel and currently selected plug-in.
Press to display the plug-in window.
ALT
Alternatively, select a channel by double clicking on one of the
insert points in the Mix window. Note that from V6.4 and
above it will be necessary to move channels 9-16, 17-24 into bay 1 channels 1-8.
Bank switching channels leaves the Plug-In Editor with the channel assigned to it. The channel EDIT tally will show
this.
AWS elta Owner's Manual
C
ONTROL
channel name is displayed at the
mode, or plug-in parameters in
E
HANNELS TO DIT
1 2 3 4
1 2 3 4
DAW Control
Page 4-19