Snap Mode; Autotakeover; Copy And Swap; Deleting Mix Passes From The Console - Solid State Logic AWS DELTA 916 Owner's Manual

Automation

Snap Mode

Snap mode uses the fader touch sensor to control both the start and end of a fader update for fast hands on changes to
mix levels. When the fader is released it ramps back to the previous mix level at a user determined rate, then returns to
replay.
Start position
when fader is
first touched
This feature is only available with Motors ON

AutoTakeover

To avoid a level jump when dropping out of write, AutoTakeover introduces nulling indicators in the scribble strip to
display the direction to move the fader to match the underlying mix level. When the fader crosses the current mix level,
it is automatically returned to replay and disconnected from the audio gain element. The fader returns to following the
mix data as soon as it is physically released.
Start position
when fader is
first touched

Copy and Swap

CS (Copy and Swap) are used to interchange or transfer mix data between channels. The required function is selected by
pressing the CS key to toggle through modes. Copy is displayed as a highlighted Cpy, Swap as an Swp. Select the function
required then hold down the source channel auto switch then press the destination channel using its auto switch. Whilst
the auto switches are active, 'src' and 'dest' will be displayed in the scribble strips above the fader. To Copy or Swap
automation data the system must be in Mix Running or Mix Review.
Copy is to a single channel only. To copy to multiple channels, repeat the Copy operation as many times as required.
The new Mix data is not saved until the subsequent Mix Pass is Ended.

Deleting Mix Passes from the Console

Mix Passes can be deleted from memory by highlighting the Mix Pass you wish to delete in the TFT screen, holding down
the Delete soft key and pressing the Confirm soft key. Mixes can also be deleted from the AWS Remote.
Page 7-28
When fader is
released it ramps back
to previous mix level
Glide time can be set
in the Setup menu if
desired
End position when
fader is released
Manual glide will
switch off automation
once past original
automation level
Scribble strip indicates
direction to move the
fader back to its
original position
AWS elta Operator's Manual