Channel Solo And Cut Tile - Solid State Logic AWS DELTA 916 Owner's Manual

DAW Control
C S
HANNEL OLO AND
C V-
15
HANNEL POT
Each channel has a continuous controller (the V-pot). This can be used to control Send levels and
Panning, and to assign Input, Output and Send routing. See Page 4-16 for more details.
The V-pot includes a push switch that is used (depending on the centre section mode) to select
sends to be pre or post fade, to mute sends and to confirm I/O selections. See Page 4-15 for more
details.
S C S
OLO AND UT WITCHES
Two sets of and
SOLO
with the signal path controlled by the channel V-pot and the lower set with the signal path under
fader control. Thus in Analogue Focus mode and with
of buttons control the analogue path and the upper the DAW channels. Changing to DAW Focus
reverses this.
When a DAW solo is active the cut buttons on the other channels flash.
Holding down
OPTION
function across all channels. If channels are already soloed then this will turn off all solo buttons,
making this a quick way to clear solos.
S I
OLO SOLATE
Holding down and pressing a channel
ALT
channel from being cut when a
C S B
HANNEL ELECT UTTON
The channel button can function as a channel select button, a track record enable or a plug-in edit enable button,
SEL
depending on the mode selected on the Master Control panel (
S S D
CRIBBLE TRIP ISPLAYS
When an AWS channel fader is controlling a DAW fader level, the channel scribble strip will indicate a four character
version of the DAW channel name. When controlling the analogue channel it displays the number of the fader, eg 'Fader
23'.
The scribble strip can also display other information such as: Automation status, Grouping information, Monitor
information, Input/Output routing, Send routing, Send Pre/Post information, fader level display and Pan position.
The V-pot scribble strip displays the DAW channel name or analogue fader number in
function (Pan, ASGN etc) in other modes.
Page 4-10
C T
UT ILE
16 19
buttons are provided on each channel. The upper set is associated
CUT
and pressing a channel
SOLO
is activated on another channel. This is particularly useful for FX return tracks.
SOLO
17
14 18
mode selected the lower set
CHANNEL
/ button will select/deselect that
SOLO CUT
will put a channel into Solo Isolate mode. This mode prevents that
, as shown on Page 4-6).
5
16
17
19
mode or the selected
CHANNEL
AWS elta Owner's Manual
16
15
14
18