Hui Automation; Automation Enables; Automation Modes - Solid State Logic AWS DELTA 916 Owner's Manual

HUI A
UTOMATION
The AWS's touch sensitive moving faders can be used to write automation for the DAW fader. Most automation functions
can be enabled from the soft key matrix below the console's display screen. Within this are menus for Automation Enables,
Automation Modes, Grouping and Editing functions.
Note: Automation data can usually only be written when the DAW is in Play, Half-Speed Play or Record.
A E
UTOMATION NABLES
Automation Enable modes (
Cuts ( ), Sends and Send Muting (
Mute
buttons will toggle automation on or off for all controls.
The automation enable includes both Channel and Send Pan.
Pan
A M
UTOMATION ODES
There are several Automation Modes (
To change automation mode on a channel select an automation mode from the soft key menu and press the auto button
on a channel fader. Holding down
automation modes on all channels. Changes within the DAW will be reflected on the console.
Refer to your DAW manual for more information on its specific automation features.
A S
UTOMATION TATUS
Pressing and holding the auto button to the left of a channel fader will display the current
automation mode for that channel in the channel scribble strip display. To display the automation
mode on all channels select the Status Group (StGr) soft menu, and press Auto.
The automation LED indications are as follows:
No LED
Green LED
Red Flashing LED
Red solid LED
Red and Green LEDs Trim automation mode
AWS elta Owner's Manual
) globally engage or disengage automation for the following items: Faders, Pans, Plug-Ins,
AuEn
). Holding down the
SnMute
) available including: Write, Touch, Latch, Trim, Read and Off.
AuMo
then selecting an automation mode from below the TFT screen will change
OPTION
D
ISPLAY
Automation off
Read automation mode
DAW is ready to write automation in write, touch or latch modes.
Writing automation data
button then pressing any of the sub menu
OPTION
DAW Control
Page 4-27