Pro Tools - Solid State Logic AWS DELTA 916 Owner's Manual

DAW Connection
P T
RO OOLS
In the Setup menu, click on Peripherals and select the MIDI Controllers tab. Using MIDI controllers 1, 2 (916) and 3 (924-
948), select HUI as the MIDI controller Type and assign the MIDI ports for this layer's DAW to the two MIDI controllers,
as listed in the table above. If Pro Tools has been assigned to Layer 1, the MIDI Controllers window should look like this:
To use the timecode display in -Control or to run legacy automtion, set the MTC generator port in the Synchronization
tab to ipMIDI port 7 (or AWS MIDI port 4 if you are using the console MIDI ports):
Also, set the MMC MIDI port in the Machine Control tab to ipMIDI port 7 (or AWS MIDI port 4 if you are using the
console MIDI ports):
Enable the two options shown above to ensure that the desk MTC reader shows the correct position following a Pro Tools
locate or scrub operation.
The legacy automation system automatically detects the timecode standard from the incoming MTC messages but will quite
happily attempt to play out stored mix data to incoming timecode with a different frame rate. This will result in small but
potentially annoying timing errors in automation playback as well as missing data if 25 frame timecode is used to play back
a Mix recorded with 30 frame timecode.
To make Pro Tools behave like a tape machine for SSL Legacy Automation enable the following in the Pro Tools Setup /
Preferences / Operation menu :
1. Timeline Insertion/Play Start Marker Follows Playback
2. Edit Insertion Follows Scrub/Shuttle
Page 1-14
AWS elta Owner's Manual