Suspending Automation; Writing Automation (Write To Start, End Or All); Automating Switches (Eg. Cuts); Automating Pans And Sends - Solid State Logic AWS DELTA 916 Owner's Manual

DAW Control
S A
USPENDING UTOMATION
To suspend all automation writing and playback for the entire project/session, press the SUSPEND AUTO
button. The button will flash red to indicate that the suspend function is active.
W A
RITING UTOMATION
In some DAW applications you can write automation data to the start, end or whole part of a
track/selection in any automation mode. To perform these functions from the AWS use the following:
+
CTRL RTZ
+
CTRL END
+ + (
CTRL SHIFT END
A S
UTOMATING WITCHES
As the console's buttons have no touch sense, automation will start being written when the button is first pressed.
CUT
In Touch mode it will return to the underlying mix pass as soon as the DAW timeline reaches the next switch change.Thus
pressing and holding a
CUT
To continue to write data until you stop select Write or Latch mode.
This also applies to plug-in buttons.
A P
UTOMATING ANS AND
As the channel V-pots have no touch sense, automation data starts being written as soon as the control is moved. In Touch
mode the system will stop writing automation and return to the previous level when you stop moving the control.
Your DAW may have a Touch-Timeout period which provides a time limit that allows for a certain time to continue
writing automation data, after which the value of the parameter returns to the value of the underlying automation pass.
Alternatively to continue to write data until you stop select Write or Latch mode.
A P -I
UTOMATING LUG
Plug-in parameters can be automated just like other V-pots and buttons. The only difference is that some DAW
applications require the controls to be armed using the on-screen menus within your DAW. Choose the automation
button in the plug-in window and enable the plug-in controls to be automated.
When automating a plug-in parameter, there is no touch sense information for the V-pot or push-push switch so in Touch
mode data will be written for as long as the control is being moved or pressed.
Using Write or Latch mode for automating plug-ins will continue writing automation data until the DAW stops.
A I
UTOMATION NDICATION FOR
If a plug-in parameter is enabled for automation the red 'LED' below the on-screen V-pot will flash. When writing
automation data, the 'LED' will light continuously.
Refer to your DAW manual for more information on all aspects of its automation system
Page 4-28
(W S
RITE TO TART
Will write automation data from the current position to the start of the track/selection.
Will write automation data from the current position to the end of the
track/selection.
or ) Will write automation data from the start to the end of the track/selection.
RTZ
( . C )
EG UTS
button will write data for as long as the button is held, overwriting any underlying automation.
S
ENDS
NS
P -I P
LUG N
, E A )
ND OR LL
ARAMETERS
AWS elta Owner's Manual