User And Control Bit Pass-Through - Solid State Logic MADI Bridge User Manual

MADI Bridge User Guide Contents
User and Control Bit Pass-Through
To enable the pass-through of AES user and control bits the device must be set to 32-bit encoding
( PCM 32 ). This is set within the Encoding section of the Device Config tab.
Brooklyn Reset
Resetting the Dante Brooklyn card to default settings is performed from Dante Controller. Under the
Device Config tab for a device select Clear Config . This clears the device name, channel labels, IP
address settings, sample rate, latency and existing audio routes.
Page 19 of 30