Viewing Input, Output And Send Routing; Assigning Signals To Multiple Channels; Assigning A Channel To Multiple Outputs - Solid State Logic AWS DELTA 916 Owner's Manual

DAW Control
I , O
NPUT UTPUT AND
The channel V-pots can also be used to assign signals to inputs, outputs and aux sends of your DAW mixer:

Viewing Input, Output and Send Routing

The Input, Output or Send routing for all DAW channels can be displayed on the channel scribble strip by holding down
the ,
INPUT OUTPUT
select which of the available sends you wish to display.
S I , O
ETTING NPUT UTPUT AND
To make or change an Input, Output or Send assignment:
1. Select +
ASSIGN INPUT
When using
SEND
2. The V-pot scribble strip will now read
channel.
3. Turn a channel V-pot to scroll through a list of available DAW inputs or outputs (names are derived from the DAW
I/O settings not the AWS). The list will appear in the channel scribble strip. The red LED below the V-pot will flash.
4. Push the V-pot knob to select the current assignment; the red LED will become solid and a '>' symbol will appear in
front of the assigned signal (for example, '>Out3-4').
5. Press the button once more to exit assign mode. This will also commit any changes made that have not been
ASSIGN
confirmed by pressing the V-pot.
6. Pressing at any time will abort the assignment process.
ESC

Assigning Signals to Multiple Channels

Holding down
OPTION
Holding down +
SHIFT OPTION
Control Panel then press the
Holding down
OPTION
channels. For example, selecting input 1 as the input to channel 9, then holding down
the channel 9 V-pot will route input 1 to channel 9, input 2 to channel 10, input 3 to channel 11 and so on across the
entire DAW.
Holding down +
SHIFT OPTION
mode on the Master Control Panel then press the

Assigning a Channel to Multiple Outputs

Hold the button and select another output. The currently assigned output will have a '>' symbol before it (for
CTRL
example, '>Out3-4'), and other added outputs will have a '+' (for example '+Out5-6') until you assign it.
In the scribble strip, an '@' symbol indicates that an item is inactive (ie routed but muted). The '$' symbol indicates that
more than one output is assigned, and at least one of those is inactive.
Page 4-14
S R
END OUTING
or button (
3
SEND
S R
END OUTING
/ or
OUTPUT SEND
, select which send you wish to change from the available send slots using the Master Send V-pot..
ASGN
then pressing any channel V-pot will assign that channel's input to all channels.
will assign that channel's input to all selected channels. Select
buttons on the channels you wish to route to.
SEL
and then pressing a channel V-pot will incrementally route that channel's input to all
ALT
+ will incrementally route that channel's input to all selected channels. Select
ALT
) on the Master Control Panel. The Master Send V-pot can be used to
on the Master Control Panel.
and the fader scribble strip will indicate the current routing for the DAW
buttons on the channels you wish to route to.
SEL
mode on the Master
SEL
and before pressing
OPTION ALT
AWS elta Owner's Manual
SEL