Plug-In Display Modes; Viewing Current Inserts (Insert Mode) - Solid State Logic AWS DELTA 916 Owner's Manual

DAW Control

Plug-In Display Modes

There are three display modes, Insert, Parameter and Assign, which are selected with the
buttons below the V-pots.
V C I
IEWING URRENT
Press the
INSERT/PARAM
In this mode the four V-pots represent four insert points on the selected channel. The currently assigned plug-ins are
displayed above each V-pot. The name of the currently active plug-in will flash.
Additional insert points can be displayed using the paging buttons.
The four V-pot push switches can be used to select an insert slot for editing or for plug-in assignment - see below.
A P -I
SSIGNING A LUG
Note: Some DAW applications will not allow assignments to be made during playback, or recording.
T A P -
O SSIGN A LUG IN TO A
1. Press the soft button to enter assign mode; the on-screen box flashes to confirm this.
ASSIGN
2. Press the V-pot corresponding to the insert slot which you wish to route to a plug-in (use the paging buttons if
necessary) then use the V-pot to scroll through a list of plug-ins and I/O slots. The names that are displayed are derived
from the DAW.
3. To confirm the assignment either:
a) Press the
to
b) Press the V-pot used to make the assignment. This will confirm the assignment and leave you in
Assign mode so you can make further assignments.
A S P
SSIGNING THE AME LUG
Follow steps 1 and 2 above to select a plug-in, then hold down the
assign a plug-in to all channels.
A T S P
SSIGNING HE AME
To assign a plug-in to selected channels select
to assign to by holding down
Follow steps 1 and 2 above to select a plug-in, then hold down
assign the plug-in to the selected channels.
Page 4-20
(I M
NSERTS NSERT ODE
button till the
INSERT/PARAM
H I/O (I
N OR ARDWARE
C I P
HANNEL NSERT OINT
button a second time. This will exit
ASSIGN
mode for editing of the last selected insert.
PARAMETER
- A C
IN TO LL HANNELS
- S C
LUG IN TO ELECTED HANNELS
SEL
and pressing the channel
SHIFT
)
box reads
INSERT
M )
NSERT ODE
:
OPTION
mode on the Master Control Panel then choose the channels you wish
keys.
SEL
+
OPTION
and
ASSIGN
; the plug-in editor is in Insert mode.
mode and switch the Plug-In Editor
INSERT
button before pressing the V-pot switch to
before pressing the V-pot switch to
SHIFT
AWS elta Owner's Manual
INSERT/PARAM