Select Mode - Solid State Logic AWS DELTA 916 Owner's Manual

DAW Control
S M
5
ELECT ODE
All 24 channel buttons become track select buttons. They perform the same function as clicking with the mouse on
SEL
a channel in the DAW.
A double click on a
SEL
Multiple channels can be selected by holding down the
down the first button you pressed while you select more channels. Note that this last method only works within
SEL
blocks of channels corresponding to a single HUI interface.
Hold down and press any
OPTION
Hold down and press any
ALT
W
ORKING WITH THE
The channel V-pots can control DAW channel pan, Send (Aux) levels and pan, routing assignment and analogue audio
levels. Each V-pot also has a switch which is activated by pushing down on the V-pot.
The channel V-pot function is selected on the Master Control Panel by the Master Send V-pot (
buttons ( ).
1 3
The scribble strip above the channel V-pots shows which function is currently selected. A further two buttons
( and
PRE/POST MUTE
P M
1
AN ODE
Select mode and the channel V-pots become pan controls for the DAW. The V-pot scribble strip displays 'Pan'.
PAN
Pressing the button on the Master Control Panel a second time (it flashes in this mode) allows you to access a
PAN
second pan control for stereo channels according to your DAW configuration. The V-pot scribble strip displays 'Pan R' in
this mode.
Press the button again to return to normal pan mode.
PAN
When panned centrally a red LED appears just beneath the channel V-pot.
Holding down displays a pan's numeric value on the channel scribble strip when you adjust the control.
ALT
C M
1
HANNEL ODE
Select mode and the channel V-pots control the analogue gain of the channel strip. The V-pot scribble strip
CHANNEL
will display the analogue fader number (eg 'Fader 12').
Switching to Analogue Focus mode will swap the analogue gain and the DAW gain between V-pot and channel fader.
Individual channels can be swapped by pressing the channel V-pot.
S M
1
END ODE
Select SEND mode on the Master Control Panel and the V-pots become level controls for any sends or aux send levels
within the DAW.
The Master Send V-pot (
The selected send is shown in the display window above the Master Send V-pot (and on the channel V-pot scribble strip).
The channel V-pot scribble strips show the name of the currently selected send. Turning a channel V-pot will alter the
level of the selected send from that channel. Holding down the
gain.
Page 4-12
button will open the channel naming pop-up for that channel.
button to select all channels.
SEL
button to invert the state of all select buttons.
SEL
C
HANNEL
, ) change the function of the V-pot push switches.
4
) selects which of the available sends (A-E or 1-5) is being controlled by the channel V-pots.
2
button while selecting further
SHIFT
V-
POTS
button allows you to make fine adjustments to the
ALT
buttons or by holding
SEL
) and six associated
2
AWS elta Owner's Manual