Cue/Fx Send Master Controls - Solid State Logic AWS DELTA 916 Owner's Manual

T B M
RACK US ASTER
The master output level controls for the eight track busses are located in the top right of the centre section.
The Track bus levels are displayed in the eight meters in the lower left-hand quarter of the LCD metering
above the bus master controls.
The gain ranges from -
corresponds to 0dB gain.
Following level control, the bus outputs can be injected with tone (using the Oscillator's TRACK switch –
see Page 3-26) and talkback (using the talkback SLATE switch to the right of the shuttle wheel – see Page
3-25) before being fed to the connector panel.
An AFL function (post tone and talkback inject) is provided for each bus. Selecting AFL on a single track
bus will route signal to both left and right AFL busses, whereas selecting it on odd and even numbered
busses will route the odd numbered output to the left AFL bus and the even numbered output to the right
AFL bus.
C /FX S M
UE END
Each channel is fitted with one Cue Stereo and two mono FX controls for use as foldback or feeds to effects
devices etc. The Cue Stereo controls in each channel may be routed to one of two busses – Cue Stereo
A or Cue Stereo B. Similarly the FX1 controls can be routed to either the FX 1 or FX 3 bus, and the
FX2 controls to the FX 2 or FX 4 bus.
The output level controls for the Cue and Aux busses are located in the top right of the centre section (see
right). The bus levels are displayed in the eight meters in the lower right-hand quarter of the LCD metering
above the bus master controls, with the cue bus components labelled AL, AR, BL and BR, and the FX
busses labelled 1 to 4.
The gain ranges from -
corresponds to 0dB gain.
An AFL function is provided for each output. Selecting AFL on a single track bus will route signal to both
left and right AFL busses, whereas selecting it on odd and even numbered busses will route the odd
numbered output to the left AFL bus and the even numbered output to the right AFL bus.
C FX
UE AND BUS INJECTION
In order allow external signals (such as a stereo sum of additional DAW channels) to be added to the Cue
and FX sends signal without using up desk channels, bus inject connections are provided on the console
connector panel for each Cue and FX bus. Signals brought in on these connectors are simply added to the
Cue and FX busses at unity-gain, before the AFL function and output level control.
AWS elta Owner's Manual
C
ONTROLS
to +10dB and the pots are indented at the '12 o'clock' position, which
C
ASTER ONTROLS
to +10dB and the pots are indented at the '12 o'clock' position, which
Analogue Operations
Page 3-25