Next' Menus - Solid State Logic AWS DELTA 916 Owner's Manual

Cue F-Mon: In In-line Track mode the CUE ST pan pot controls pan for the Channel path whenever it is routed to a
stereo bus, or a Track bus with Pan selected, and the Cue pan follows the main channel pan. Select Cue F-Mon (Cue
Follows Monitor path) to force the CUE ST bus to always follow.
EFX CHOP: (Only available when EFX is active) Switches the channel's EFX send from the Track bus to the Channel
output. The CHOP PRE/EFX LED in the channel strip lights green to indicate that the channel output is being fed by
the EFX. (AWS elta 924 EFX CHOP – See section 3.9).
In-Line Mix – RETURN OFF: PRE/POST toggles the pick-off point
for the Monitor Path in RETURN Mode.
In-Line Mix – RETURN ON:
In-Line Track: CUE F-CH is the existing CUE follow CHANNEL
PAN, which is activated automatically when the Monitor Path (In-Line Mix)
or Channel Path (In-Line Track) is routed to console mix busses.
Auto-M and S-Cue are the existing Auto Monitor and SuperCue options.
'NEXT' M
ENUS
NEXT selects the next page of Menu Key functions – there are two additional menu pages. The NEXT button should also
be ON if any option has been enabled in the secondary menus.
Menu 1: In-Line Track and In-Line Mix – RETURN ON
MON INS activates the Insert point in the Monitor path (Channel R).
The channel insert is controlled from the existing front panel INS switch.
M-CHOP PRE switches the Monitor path output (Channel R) to the Pre Fader signal. The channel path Pre Fader signal
is controlled from the existing front panel PRE switch.
Menu 2: In-Line Mix
CH PAN* routes the Post Channel pan signal to the channel outputs.
MON PAN* routes the Post Monitor pan signal to the channel outputs.
*These two functions intercancel.
RETURN takes you back to the default soft key function set.
If an EFX send has been enabled from the selected channel strip, the EFX
CHOP key will be shown.
EFX CHOP routes the selected EFX send to the channel or Monitor path output depending on which path the send is
assigned to. This intercancels with CH PAN and MON PAN.
If EFX CHOP is selected – and if the Stereo CUE is the active source – then a further option is available (replacing the
CH PAN and MONITOR PAN buttons).
CUE PAN routes the stereo CUE Pan outputs to the Direct outputs.
The CUE source will be whichever path is assigned to the CUE mix.
Note that if CUE-F CH is active it will be the ALT_PAN signal not the CUE_PAN.
AWS elta Owner's Manual
Analogue Operations
POST CUE F-CH
CUE F-CH
Auto-M S-Cue CUE F-CH
MON INS M-CHOP PRE
CH PAN MON PAN
CUE PAN EFX CHOP
NEXT
NEXT
NEXT
NEXT
RETURN
RETURN
Page 3-5