Automation; Talkback; Monitor Section; Desk Setup - Solid State Logic AWS DELTA 916 Owner's Manual

A
UTOMATION
Motors Off Mode:
Show MTC Display:
T
ALKBACK
Talkback switches are:
Listen switch is:
Red light switch is:
TB switches disable Listen:
TB to FB:
See Communications for more details of these options
M
ONITOR SECTION
Monitor Gain Display:
Monitor Set CAL level:
See Monitor Level Display and Calibrated listening level for more details of these options
Solo Gain boost:
Isolated channels AFL on solo:
D S
ESK ETUP
Input Cut Enable:
Analogue Meter Scaling:
DAW setup parameters can be found in section 4 of this manual; see page 4-3 for more details.
D
ESK SETTINGS
Scribble Strip Brightness:
Turn Off Display After:
The scribble-strip displays can be turned off by turning the control pot clockwise (beyond 8 or 6) to 'Off'.
On occasion, when changing the status of some of the above functions, you will be prompted to reboot your AWS elta
console. It is possible to do this without reaching the Power switch at the rear of the console through the addition of a
soft menu RESTART. When you select this you will be prompted to CONFIRM and your console will reboot.
AWS elta Owner's Manual
Touch sense can be enabled or disabled.
Turn the timecode display on or off.
Select the operation of the talkback buttons: Momentary / Latching / Auto
(Play) / Auto (Record).
Select the operation of the Listen buttons: Latching / Auto (Play) / Auto
(Record).
Select the operation of the Red Light: Manual / Auto (Play) / Auto (Record).
This allows the Listen function to be switched off when talkback is activated,
thus avoiding feedback problems.
(Sums / Replaces) When assigning talkback to foldbacks, this option defines
whether talkback sums with or replaces the normal foldback signal.
The calibration of the main monitor Gain pot and display can be set to one
of three industry-standard monitoring modes: Music (Off to 11) / Film (Off
to 95dB) / Gain (Off to 0dB)
When in Film mode, adjust the calibrated listening level: 70 - 90 (dB).
Automatically increases the monitor level when a SOLO or AFL is activated
(Range: 0-10dB).
Set solo-isolated channels to automatically solo in AFL (ON/OFF).
If set ON, the channel strip CUT button will cut prefade sends, ie. Aux and
CHOP sends (ON / OFF).
Set the analogue level corresponding to 0dBfs on the console meters. (Range
DAW
18, 20, 22, 24 dBu).
Use this to adjust the channel scribble strip brightness (range: 1-6)
Shuts off the TFT display after a predetermined time: 30 mins to 5 hours in
30 minute increments.
Analogue Operations
SETUP
Page 3-31