Solid State Logic AWS DELTA 916 Owner's Manual page 31

• Using an RJ45 cable, make a direct network connection between the network port on your AWS to a network port
on your workstation computer and check that the IP address is set to FIXED in the console's
SSL > MISC > NET menu.
• Open System Preferences and click on Network. Create a new location by clicking where it says Location, scroll down
to Edit Locations and click the '+' sign. Name the new location AWS.
• Next, select the Ethernet port which is connected your AWS and configure as shown below:
Ethernet must
be the primary
interface
• If your Macintosh features multiple network ports, you should set the priority of these so that the Ethernet port
connected to your AWS is at the top of the list.
• Alternatively, if you have already created a separate Location for your existing network you can simply delete the
unused ports (Airport, Firewire) from the AWS location so that only the network port connected to AWS is
remaining.
Please note that currently OS X does not allow two ports to be used for IP traffic. As such, the connection to your main
network will not be available while the AWS is connected.
Note also that if your workstation computer is a Mac, you should ensure that your Mac Airport is switched off. We strongly
recommend this as Airport is known to cause conflicts with ipMIDI data. If you wish to use the internet, we suggest you
configure AWS with a Router/Switch (see Connection Using DHCP).
AWS elta Owner's Manual
DAW Connection
New 'AWS'
Location
Must match the
AWS IP address
Page 1-9