Dynamics; Insert Point - Solid State Logic AWS DELTA 916 Owner's Manual

Analogue Operations
I P
NSERT OINT
To switch the channel insert into circuit, press the INS IN switch (
centre of the EQ section – the LED to its left lights yellow to indicate that it is active. Press PRE to place the insert
immediately before the EQ in the processing chain.
AWS 948
When in Stereo channel mode, the insert send and return is stereo. In In-line modes, the left insert connections are used
for the primary channel path and the right connections for the Monitor path – in this mode the 2nd insert point is
switched from the Channel Setup screen (as described on Page 3-4).
S P
IGNAL ROCESSING
The table below lists the processing order possibilities and the button combinations which accomplish them. The buttons
involved are the IP and OP switch in the DYNAMICS area of the meter bridge, and the insert's PRE switch, located
above the INS IN switch mid-way down the EQ section:
Processing Order
EQ
Insert

Dynamics

Dynamics
EQ
Insert
Insert
The processing order will be reflected in the Channel Setup screen
Page 3-10
O
RDER
Dynamics
EQ
EQ
Insert
Insert
Dynamics
EQ
in the pictures on the previous page) in the
3
Active Switches
Insert No routing switches active
Dynamics PRE
IP
Insert
EQ IP + PRE
OP
Dynamics
EQ OP + PRE (948)
OP + PRE (924)
Dynamics
AWS elta Owner's Manual