Measurement Settings - Mitsubishi Electric AE-200A Instruction Book

6-7-4. Measurement settings

Set the indoor and outdoor units and the electricity meter required when the billing function is used.
When [Non-use] is selected in "Apportioning with metering device" in section 6-7-1 "Billing function settings", this
setting is not required.
Procedures
1. Click [Billing Function Settings] > [Measurement] to access the measurement settings screen.
Note
• The "Expansion controller No.", "Address" and "Metering device name" set in section 6-6-6 "PI controller
settings" will be displayed.
• Metering device name cannot be changed on this screen.
Target centralized
controller
Select one of the connected
centralized controllers
whose measurement
settings are to be made.
PI controller address
Displays the address of the
connected PI controller.
2. Check that the controller numbers ([Exp1] to [Exp4]) selected in "Target centralized controller" are displayed
in "PI controller address", that the addresses of the PI controllers connected to those expansion controllers
are displayed, and that the names of Ch1 to Ch4 on the PI controllers are displayed in "Metering device
name".
Note
• For measurement pulse input of centralized controller (AE-50/EW-50), "PI" will be shown as the address.
3. In "Unit type", select [Indoor unit], [Outdoor unit] or [Others] as the type for the unit for which electricity is
being metered by the Ch1-4 metering devices.
① When [Indoor unit] is selected, (
② When [Outdoor unit] is selected, (
③ When [Others] is selected, nothing will appear in "Connected units".
4. Click ( ) or (
5. Select the centralized controller ([Exp1] to [Exp4]) of the indoor unit or outdoor unit.
6. Select the indoor unit or outdoor unit address number to be registered.
The selected unit addresses will appear with a yellow-green background.
Click again to deselect. The deselected unit addresses will appear with a light-gray background.
WT07442X02
Click to save the settings.
) will appear in "Connected units".
) will appear in "Connected units".
) in "Connected units" to display the unit address selection screen.
Save
90
Unit type
Select the unit types
connected to each of the PI
controller channels.
Connected units
Click to display the unit
address selection screen.
Back
Click to display the previous
settings without making any
changes.