Saving The Settings - Mitsubishi Electric AE-200A Instruction Book

(5) Decimal point character for CSV file (Dot/Comma), Separator character for CSV file (Comma/
Semicolon)
Procedures
1. Set the format of the CSV file (apportioned results, charges calculation results from the Charge Calculation
Tool).
Important
• This setting must be the same with the "Decimal point character for CSV file" and "Separator character for
CSV file" settings on the [Basic Settings] > [Basic System Settings] screen on the Initial Setting Tool. If the
settings are not the same, a error message "The CSV file format is not appropriate. Check the directory
from which the CSV file is acquired." will appear.
• When multiple AE-200 units are connected, make the same settings for all of them.
• If the settings on the AE-200 and the Charge Calculation Tool are not the same, the charges will not be
properly calculated.
(6) Unit price settings (Charge rate settings)
In systems where electric energy is metered (with-metering-device method), set the Unit prices 1 to 5 per 1
[kWh]. "Calorimeter [/MJ]", "Water meter [/m3]" and "(No measurement unit) [/1 measurement unit]" can also
be set.
In systems where the electric energy is entered manually (no-metering-device method), set the charge rate.
On the Initial Setting Tool, unit prices 1 to 5 can be assigned to periods such as days of the week and
seasons.
Procedures
1. Set the unit price for air-conditioner [/kWh].
(When a calorimeter or water meter is connected to the PI controller, the unit price can also be set for
"Calorimeter [/MJ]", "Water meter [/m3]" and "(No measurement unit) [/1 measurement unit]".)
Important
• Change the settings for each time period on the Initial Setting Tool.
• Note that even when time periods are set, the charges will not be calculated correctly if no unit price is
entered.
• For systems where the electric energy is entered manually (no-metering-device method), set the electricity
charge rate in unit prices 1 to 5.
E.g.: When the nighttime rate is one-third of the daytime rate
Set unit price 1 (nighttime) to "1" and unit price 2 (daytime) to "3".
Set the unit price time periods on the Initial Setting Tool.

4-1-3. Saving the settings

Click [OK] to save the settings.
WT07442X02
39