Mitsubishi Electric AE-200A Instruction Book page 28

(3) Closing date setting (automatic output)
Carry out the following procedures to set the date for "Monthly" automatic output in "Closing date setting".
In this setting, you can set the closing date to output the charge calculation results.
Make sure that this date matches the closing date set on the "Energy management list" on the AE-200.
Procedures
1. Touch [Energy Mgmt] > [Energy management list] on the
AE-200's LCD, and check the display period of electric
energy.
2. Set the closing date based on the display period of
electric energy.
Example 1. If the period is "2015/03/01-2015/03/31",
the final day is the last day of the month,
so you should select "End of month" as the
closing date.
Example 2. If the period is "2015/03/11-2015/04/10",
you should select "Day (10) of each month"
as the closing date.
• When the end of the month is selected
When the end of the month is selected, the charge calculation results for each month will be output on the
1st of the following month.
For example, the data output at 5:00 AM on February 1, 2015 will be the charge calculation results for
January 1-31, 2015.
• If another day of each month is selected
If you select "Monthly", click the pull-down menu for "Day" and select a date between 1 and 28 as the
desired output date.
Once you select a date, the charge calculation results for the month preceding the selected date will be
output on the day after the selected date.
For example, if you select monthly output on the 25th on April 1, 2015, the next data output will be at 5:00
AM on April 26, 2015, and the charge calculation results for the period from March 26, 2015 to April 25,
2015 will be output.
Note
• Settings are required to carry out the closing date calculation (automatic output).
• If [Output] is selected in both printing and CSV output settings, you cannot set separate closing dates for
printing and CSV output.
• 29th, 30th or 31st cannot be set as the closing date for every month.
• There are two types of "Closing date": Calculation on the closing date (automatic output) <set on the
Charge Calculation Tool>; or energy management list (monthly display) <set on Initial Setting Tool> shown
on the AE-200's LCD.
• The "Energy management list" is displayed as of the day after the closing date.
WT07442X02
28
Display period of electric energy