Preparation And Flow Of The Initial Setting Tool - Mitsubishi Electric AE-200A Instruction Book

6-4-6. Preparation and flow of the Initial Setting Tool

To change the AE-200/AE-50/EW-50 settings (for systems with initial settings already made), make sure to first
acquire data of the settings status using the Initial Setting Tool and then follow the procedure below. If you follow
a different procedure, the settings may not be correctly made.
Procedures
1. Connect the AE-200/AE-50/EW-50 to a PC (the Initial Setting Tool) via a LAN.
2. Start up the Initial Setting Tool.
3. Click [New] or [Open].
To load a settings file stored on the PC, select [Open].
Otherwise, select [New].
4. Register the IP address of the AE-200/AE-50/EW-50 in [Basic Settings] > [System Configuration].
Refer to section 6-5-1 "System Configuration settings" for details.
5. Click [Data acquisition] > [Acquire data] in the tool bar to load the AE-200/AE-50/EW-50 settings information
onto the Initial Setting Tool.
* Enter the user ID and password for an AE-200/AE-50/EW-50 maintenance user.
6. Click [File] > [Save As...] in the tool bar to save the pre-change initial settings data.
Note
• For backup purposes, save the pre-change settings file under a file name such as "date + pre-change".
• At this point, the settings will not be sent to the AE-200/AE-50/EW-50.
7. Change the initial settings. Refer to sections 6-5 "Basic settings", 6-6 "Unit settings", and 6-7 "Billing function
settings".
8. Click [File] > [Save As...] in the tool bar to save the settings data on the PC.
Note
• Save the data using a different name to the pre-change settings file, such as "date + post-change".
• At this point, the settings will not be saved on the AE-200/AE-50/EW-50.
9. Click [Send] > [Send settings] to overwrite the AE-200/AE-50/EW-50 settings data registered in System
Configuration settings.
WT07442X02
67