Replacing The Ae-50/Ew-50 - Mitsubishi Electric AE-200A Instruction Book

8-4. Replacing the AE-50/EW-50

When replacing the AE-50/EW-50, the stored apportioned data needs to be restored.
This section describes how to restore the AE-200 apportioned data (backup) onto the AE-50/EW-50.
AE-200
Apportioned
data
If the AE-50/EW-50
fails, the apportioned
data will also be
deleted.
1. Make the network settings for the AE-50/EW-50.
2. Make the normal initial settings on the AE-200.
3. Carry out the data restore procedure.
Touch [Maintenance] > [Apportioned data] > [Restore], select the replaced AE-50 or EW-50 as the
"Centralized controller" and then touch [Restore].
(With each touch, the display changes in the following sequence: [AE200]→[Exp1]→[Exp2]→[Exp3]→
[Exp4].)
Note
• Be sure to select AE-50/EW-50.
If you inadvertently select [AE200], the apportioned calculation results data will all be deleted.
WT07442X02
AE-50/EW-50
Replacing the
AE-50/EW-50
Apportioned
data
AE-50/EW-50
Apportioned
data
Replaced AE-200
Apportioned
data
The AE-200 restores
the apportioned data.
120
AE-50/EW-50
Apportioned
data
AE-50/EW-50
Empty