Billing Function Settings - Mitsubishi Electric AE-200A Instruction Book

6-7. Billing function settings

This section explains how to make billing function settings on the Initial Setting Tool.
Note
• The settings screen for the AE-200 system to which [AE-200 (Billing)] is set as "Controller type" in section
6-5-1 "System Configuration settings" will be displayed.
6-7-1. Billing function settings
Make the settings for charge calculation.
Note
• On the LCD, set "AE-200 Apportion" to [Use].
• If there are multiple AE-200 units using the apportioned electricity billing function, the settings are required
for each AE-200.
Procedures
1. Click [Billing Function Settings] > [Billing Function] to access the Billing Function Settings screen.
Target centralized
controller
Select one of the connected
centralized controllers
whose billing settings are to
be made.
Apportioning mode setting
Set the apportioning modes
for the operating electric
energy and standby electric
energy of outdoor units and
indoor units.
Warning - possibility of
damaged metering device
Set to enable or disable the
warning display function of
damaged metering device.
2. In "Apportioning with metering device", select [Use] or [Non-use].
To apportion electric energy using an electricity meter, select [Use].
"Apportioning mode setting" can be made only when [Use] is selected.
To calculate the charge rate by manually entering the electric energy rather than using an electricity meter,
select [Non-use].
Important
• Ensure that this setting matches the [Connected]/[Not connected] setting for "Metering device connection"
on the [Advanced Settings] screen on the Charge Calculation Tool.
If the settings are not the same, the following error message will be displayed:
"Metering device connection settings (connection or non-connection) on the Charge Calculation Tool
and the AE-200 do not match. Check the [Metering device connection] setting on the Advanced Settings
screen, and check for proper AE-200 billing function settings."
3. In "Power source of A-control unit", select [Same power source (O/U - I/U)] or [Separated power source (O/U
- I/U)].
The [Same power source (O/U - I/U)] setting denotes a configuration in which the A-control unit outdoor units
and indoor units are receiving power from the same electricity meter power source. The [Separated power
source (O/U - I/U)] setting denotes a configuration in which the A-control unit outdoor units and indoor units
are receiving power from different electricity meter power sources.
WT07442X02
Save
Click to save the settings.
84
Apportioning with
metering device
Set a metering device
connection.
Power source of A-control
unit
Select a power source
setting for the A-control unit
outdoor units and indoor
units.
Back
Click to display the previous
settings without making any
changes.