Mitsubishi Electric AE-200A Instruction Book page 103

[2] Charges settings
Check that none of the settings differ from those set in section 6-7-5 "Charges settings".
⑦ ⑧
⑦ Weekly charges (Available)
⑧ Seasonal charges (Available/Not Available)
⑨ Special day charges (Available/Not Available)
This will be judged based on the number of pattern allocation "0" (Not Available) or "1 or more" (Available).
⑩ Closing date (End of month/Day XX of each month)
Note
• There are two types of "Closing date": Calculation on the closing date (automatic output) "Charge
Calculation Tool settings"; or energy management display (monthly) "Initial Setting Tool settings" shown
on the AE-200's LCD. Set the same closing date so that the electric energy consumed by each tenant
matches the electric energy consumption displayed in the energy management list on the AE-200's LCD.
[3] Centralized controller settings (for systems with metering devices)
Check that there are no errors in the settings. (Check that none of the settings differ from those set in 6-6-6 "PI
controller settings".)
⑪
⑪ Address
For a PI controller, this will be shown as "(Expansion controller No.) - (Unit address)".
⑫ Ch
⑬ Metering device name
For a PI controller, if the name of the metering device is not registered, this will be shown as "(Unit address)
- (Ch)".
⑭ Metering device type
This shows the unit type set in section 6-7-4 "Measurement settings".
⑮ Pulse weight
⑯ Unit
WT07442X02
⑨ ⑩
⑫ ⑬ ⑭ ⑮
103
⑯