Mitsubishi Electric AE-200A Instruction Book page 29

(4) IP address setting
This section explains how to set the IP address used to automatically acquire "Energy management" data
and "Metering device" data from the AE-200.
Procedures
1. Click [Add] in the IP address setting.
2. When the "AE-200 from which data is automatically acquired" screen appears, enter the IP address of the
AE-200 for which charges will be calculated along with the building manager ID and password.
3. Click [Check communication] and check that the tool can communicate with the AE-200. When the
communication is successful, a message "Communication succeeded" will appear.
4. Click [OK] and check that the address has been added in the IP address settings column.
5. If there are multiple AE-200 units for which charges are to be calculated, repeat procedures 1 to 4 above to
register all the AE-200 units for which charge calculation is required.
Note
• Settings are required to carry out the closing date calculation (automatic output).
• When [Do not merge] is selected in "Merger of energy management blocks with same name" in the Charge
Calculation Tool's [Advanced Settings], units will be displayed in the "AE-200 No.X + energy management
block name" format to distinguish the energy management block names.
(Here, the "No." for an AE-200 is its number in this sequence of IP address settings, starting from No.1.
You can change the order by selecting the IP address and then clicking the [ ▲ ] or [ ▼ ] button.)
(Refer to section 4-1-2 "Charge Calculation Tool settings".)
(Example: When the name of the energy management block connected to AE-200 No.1 is "1F tenant",
"AE-200 No.1 1F tenant" will be displayed.)
• Even when "Merge" is selected, the metering device names in the charge calculation results for each
metering device will not be merged.
• The charge calculation results for each metering device will be displayed in the "AE-200 No.X + metering
device name" format regardless of the setting for merging energy management blocks with the same
name.
• To change the settings, select an IP address and click [Edit].
WT07442X02
29