Basic Settings; System Configuration Settings - Mitsubishi Electric AE-200A Instruction Book

6-5. Basic settings

6-5-1. System Configuration settings

Make the configuration settings of centralized controllers and expansion controllers on the Initial Setting Tool.
Click [Basic Settings] > [System Configuration] to access the system configuration settings screen.
Note
• Connection settings can be made for up to 40 centralized controllers.
AE-200 units set as the [AE-200 (Billing)] or [AE-200 (No M-NET)] will not be included in this 40
controllers.
• The connection destination IP address of the expansion controller must be set with the AE-200
beforehand.
Refer to section 6-2-2 "AE-200 unit settings" for how to make AE-200 unit settings.
Procedures
1. Click the "Controller type" pull-down menu (▼) and select [AE-200 (Billing)].
2. Enter the IP address of the AE-200 in "Destination IP address".
3. Click the "Expansion controller" checkbox according to the number of expansion controllers.
4. Enter the IP address of the AE-50/EW-50 in "Destination IP address".
5. If there are multiple AE-200 units, click the "Centralized controller" checkbox and repeat procedures 1 to 4.
6. Click [Save] after completing the settings.
Note
• The selectable options vary depending on the type of centralized controller selected in the "Controller
type" of Centralized controller.
• The AE-200/AE-50/EW-50 IP address cannot be changed in this setting screen.
To set the AE-200/AE-50/EW-50 IP address, set on the AE-200/AE-50's LCD, the web browser for initial
settings, or the quick IP address setting switch (EW-50 only).
Controller type
Set the centralized controller
type.
Centralized controller
Check the checkbox to add
a centralized controller.
The checkbox of the first
row is checked and cannot
be unchecked.
Destination IP address
Set the IP address of the
centralized controller.
WT07442X02
Save
Click to save the settings.
68
Expansion controller
Check the checkbox to add
an expansion controller.
Destination IP address
Set the IP address of the
expansion controller.
Back
Click to display the previous
settings without making any
changes.