Mitsubishi Electric AE-200A Instruction Book page 91

7. After the settings are completed, click [Save].
Note
Sub outdoor units do not need to be registered. They are included in the outdoor units of the same power
system.
If the pulse weight set in section 6-6-6 "PI controller settings" is not [kWh] ([m3], [MJ] or [--]), only [Others]
can be selected.
• If the electricity meter is used for purposes other than air conditioning, or if there are metering devices
other than electricity meters connected, select [Others].
• If [Same power source (O/U - I/U)] is selected in "Power source of A-control unit" in section 6-7-1 "Billing
function settings", select [Outdoor unit] as the unit type.
• For an indoor unit, the unit address set for an air conditioner, air conditioner (A-control), Air To Water (PWFY)
unit, HWHP (CAHV, CRHV) unit, LOSSNAY, or LOSSNAY with heater/humidifier in section 6-6-1 "Group
settings", or a LOSSNAY with heater/humidifier set in section 6-6-2 "Refrigerant System settings" can be
selected.
• For an outdoor unit, the unit address set for an outdoor unit in section 6-6-2 "Refrigerant System settings"
can be selected.
• The unit addresses set in section 6-6-6 "PI controller settings" or 6-6-7 "AI controller settings" cannot be
selected.
WT07442X02
91