Mitsubishi Electric AE-200A Instruction Book page 80

[2] Energy management block settings
Procedures
1. Click [Unit Settings] > [Energy Management Block] to access the energy management block settings screen.
Target centralized
controller
Select one of the connected
centralized controllers
whose energy management
block settings are to be
made.
Energy management block
No.
2. In "Energy management block name", enter the energy management block number in 20 characters or less.
Note
• By setting the same name for the energy management blocks that are connected to different AE-200 units,
the calculation results can be merged.
Refer to section 4-1-2 "Charge Calculation Tool settings" ((4) "Display order of charge calculation result
(Number/Name), Merger of energy management blocks with same name (Merge/Not merge)") for details.
3. Click the icon in "Member block registration" (
4. Select one of the expansion controllers ([Exp1] through [Exp4]) of the member block to be registered.
5. Select the block number of the member block to be registered, and click [OK].
Note
• To show the block name, move the cursor to the block number.
6. Click the icon in "Member LOSSNAY with heater/humidifier registration" (
selection screen.
7. Select the expansion controller ([Exp1] to [Exp4]) of the LOSSNAY with heater/humidifier to be registered.
8. Select the unit address of the LOSSNAY with heater/humidifier to be registered, and click [OK].
Note
• Register the LOSSNAY with heater/humidifier that is an interlocked unit.
• To show the block name, move the cursor to the block number.
9. Click [Save] to save the settings.
WT07442X02
Save
Click to save the settings.
) to display the member block selection screen.
80
Member LOSSNAY
with heater/humidifier
registration
Click to display the screen
for selecting LOSSNAY with
heater/humidifier.
Member block registration
Click to display the screen
for selecting member blocks.
Back
Click to display the previous
settings without making any
changes.
) to display the unit address