Configuring Garp Timers And Gmrp - Dell M6220 User Configuration Manual

Command
show mvr interface
interface
show mvr traffic

Configuring GARP Timers and GMRP

Beginning in Privileged EXEC mode, use the following commands to
configure the GARP timers and to control the administrative mode GMRP on
the switch and per-interface.
Command
configure
garp timer {join | leave |
timer_value
leaveall}
gmrp enable
interface
interface
gmrp enable
exit
exit
show gmrp configuration View the administrative status of GMRP on the switch
Purpose
View information about the MVR configuration for a
specific port.
View information about IGMP traffic in the MVR table.
Purpose
Enter global configuration mode.
Adjust the GARP application join, leave, and leaveall
GARP timer values
timer_value
The variable is in centiseconds. The range is
10-100 for join, 20-600 for leave, and 200-6000 for
leaveall.
Enable GMRP globally on the switch.
Enter interface configuration mode for the specified port
interface
or LAG. The
and number, for example gigabitethernet 1/0/3. For a
LAG, the interface type is port-channel.
You can also specify a range of ports with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
Enable GMRP on the interface or range of interfaces.
Exit to Global Config mode.
Exit to Privileged EXEC mode.
and all interfaces.
Configuring L2 Multicast Features
variable includes the interface type
755