Configuring Nsf Settings For Ospf (Pcm6220 And Pcm6348 Only) - Dell M6220 User Configuration Manual

Configuring NSF Settings for OSPF (PCM6220 and PCM6348 Only)

Beginning in Privileged EXEC mode, use the following commands to
configure the non-stop forwarding settings for OSPF.
Command
configure
router ospf
nsf [ietf ] helper strict-lsa-
checking
nsf [ietf ] restart-interval
seconds
nsf helper [planned-only] Allow OSPF to act as a helpful neighbor for a restarting
nsf [ietf] [planned-only]
1010
Configuring OSPF and OSPFv3
Purpose
Enter global configuration mode.
Enter OSPF configuration mode.
Require that an OSPF helpful neighbor exit helper mode
whenever a topology change occurs. Use the ietf keyword
to distinguish the IETF standard implementation of
graceful restart from other implementations.
Configure the length of the grace period on the restarting
router.
seconds
The keyword is the number of seconds that the
restarting router asks its neighbors to wait before exiting
helper mode. The restarting router includes the restart
interval in its grace LSAs (range 1–1800 seconds)
router. Include the planned-only keyword to indicate
that OSPF should only help a restarting router
performing a planned restart.
Enable a graceful restart of OSPF.
• ietf — This keyword is used to distinguish the IETF
standard implementation of graceful restart from other
implementations. Since the IETF implementation is
the only one supported, this keyword is optional.
• planned-only — This keyword indicates that OSPF
should only perform a graceful restart when the restart is
planned (i.e., when the restart is a result of the initiate
failover command).