Default Routing Interface Values - Dell M6220 User Configuration Manual

Default Routing Interface Values

By default, no routing interfaces are configured.
When you create a VLAN, no IP address is configured, and DHCP is disabled.
After you configure an IP address on a VLAN or loopback interface, routing is
automatically enabled on the VLAN interface, and the interface has the
default configuration shown in Table 31-1.
Most interface configuration parameters are not applicable to loopback
interfaces, so you cannot change the default values. However, when you create
a loopback interface, the default values are similar to those of VLAN routing
interfaces, as Table 31-1 shows.
Table 31-1. VLAN Routing Interface and Loopback Interface Defaults
Parameter
Forward Net Directed Broadcasts
Encapsulation Type
Proxy Arp
Local Proxy Arp
IP MTU
Bandwidth
Destination Unreachables
ICMP Redirects
When you create a tunnel, it has the default values shown in Table 31-2
Table 31-2. Tunnel Interface Defaults
Parameter
Tunnel mode
Link Local Only Mode
Source address
Destination address
872
Configuring Routing Interfaces
Default Value
Disabled
Ethernet (N/A for loopbacks)
Enabled
Disabled
1500
Not configured.
Enabled
Enabled
Default Value
6-in-4 configured
Disabled
None
0.0.0.0