Dell M6220 User Configuration Manual page 285

Command
interface
add interface
intf-list
duplex {half | full}
mtu disable
negotiation
speed {10 | 100}
lacp {auto | static | off} Configure the LACP mode of the group to dynamic
minimum active uplinks
{1-4}
CTRL + Z
show port-aggregator
group summary
show port-aggregator
port summary
show port-aggregator
port-channel summary
show port-aggregator
vlan summary
show mac address-table
port-aggregator group
{1–8}
Purpose
Add member Ethernet ports to the Aggregator Group.
interface
• –Specify the Ethernet interface type, for
example GigabitEthernet or TenGigabitEthernet.
intf-list
• — List of Ethernet interfaces to add. Separate
nonconsecutive ports with a comma and no spaces. Use a
hyphen to designate a range of ports.
Configure the full/half duplex operation of all member
ports in the aggregator group/zone.
Set the MTU size to default (1518) on all the member
ports in the aggregator group/zone.
Enable auto-negotiation of all member ports in the
aggregator group/zone.
Configure the speed of all member ports in the aggregator
group/zone.
(auto), static, or none (off).
Set the minimum number of uplinks to be active for the
aggregator group.
Exit to Privileged EXEC mode.
View summary information about the Port Aggregator
groups.
View summary information about the Port Aggregator
group member ports.
View summary information about the LAG configuration
for all groups.
View summary information about the VLAN configuration
for all groups.
View the MAC address table entries for the specified Port
Aggregator group.
Managing General System Settings
285