Dell M6220 User Configuration Manual page 601

Hide thumbs Also See for M6220:

Table of Contents

switchport mode trunk

switchport trunk

{allowed vlan

|native vlan

Enter interface configuration mode for the specified

interface. The

and number, for example gigabitethernet 1/0/3.

You can also specify a range of interfaces with the interface

range command, for example, interface range

gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,

Configure the interface as a tagged layer 2 VLAN interface.

Set the list of allowed VLANs that can receive and send

traffic on this interface in tagged format when in trunking

can receive and send traffic on this interface in tagged

format when in trunking mode. Separate non-consecutive

VLAN IDs with a comma and no spaces. Use a hyphen to

designate a range of IDs.

• all—Specifies all VLANs from 1 to 4093. This keyword

is not allowed on commands that do not permit all

VLANs in the list to be set at the same time.

• add—Adds the list of VLANs to the allowed set.

• remove—Removes the list of VLANs from the allowed

set. Removing the native VLAN from a trunk port

forces the port to allow tagged packets only.

• except—Allows all VLANs other than those in the list.

4093 or a continuous range of VLANs described by two

VLAN numbers, the lesser one first, separated by a

received on this interface are switched in the native

VLAN. Transmitted packets in this VLAN are sent

Exit to Privileged EXEC mode.

variable includes the interface type

— Set the list of allowed VLANs that

format is all | [add | remove | except]

—Either a single VLAN number from 1 to

— The untagged VLAN. Untagged packets

Configuring VLANs

M8024 M6348 M8024-k