Configuring Ospfv3 Route Redistribution Settings - Dell M6220 User Configuration Manual

Configuring OSPFv3 Route Redistribution Settings

Beginning in Privileged EXEC mode, use the following commands to
configure OSPFv3 route redistribution settings.
Command
configure
ipv6 router ospf
redistribute {static |
connected} [metric
metric
] [metric-type {1 |
tag
2}] [tag ]
exit
exit
show ipv6 ospf
Purpose
Enter global configuration mode.
Enter OSPFv3 configuration mode.
Configure OSPFv3 to allow redistribution of routes from
the specified source protocol/routers.
• static — Specifies that the source is a static route.
• connected — Specifies that the source is a directly
connected route.
metric
• — Specifies the metric to use when
redistributing the route. (Range: 0–16777214)
• metric-type 1 — Type 1 external route.
• metric-type 2 — Type 2 external route.
tag
• — Value attached to each external route, which
might be used to communicate information between
ASBRs. (Range: 0–4294967295)
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View OSPFv3 configuration and status information,
including information about redistributed routes.
Configuring OSPF and OSPFv3
1019