Configuring And Viewing Pim-Sm For Ipv6 Multicast Routing - Dell M6220 User Configuration Manual

Command
exit
exit
show ip pim
show ip pim interface vlan
vlan-id
show ip pim neighbor
[interface vlan
show ip pim rp-hash
groupaddr
show ip pim bsr-router
[candidate | elected]
show ip pim rp mapping

Configuring and Viewing PIM-SM for IPv6 Multicast Routing

Beginning in Privileged EXEC mode, use the following commands to
configure PIM-SM for IPv6 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-SM information.
Command
configure
ip routing
ipv6 unicast-routing
ipv6 pim sparse
ip mld router
ip multicast
1256
Managing IPv4 and IPv6 Multicast
Purpose
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View system-wide PIM information.
View the PIM information for the specified interface.
View a summary or all the details of the multicast
vlan-id
| all] table.
View the RP router being selected for the specified
multicast group address from the set of active RP
routers. The RP router for the group is selected by
using a hash algorithm.
View the bootstrap router (BSR) information.
View group-to-RP mappings of which the router is
aware (either configured or learned from the BSR)
Purpose
Enter global configuration mode.
Enable IP routing. Routing is required for PIM
operation.
Enable IPv6 routing. IPv6 routing is required for IPv6
PIM.
Enable PIM-SM as the multicast routing protocol on
the switch.
Enable MLD. MLD is required for the proper
operation of IPv6 PIM.
Enable IPv4/IPv6 multicast.