Managing The Sdm Template; Configuring The Operational Mode And Port Aggregator Features - Dell M6220 User Configuration Manual

Managing the SDM Template

Beginning in Privileged EXEC mode, use the following commands to set the
SDM template preference and to view information about the available SDM
templates.
Command
configure
sdm prefer {dual-ipv4-
and-ipv6 default| ipv4-
routing {data-center |
default}}
CTRL + Z
show sdm prefer
template
[ ]

Configuring the Operational Mode and Port Aggregator Features

Beginning in Privileged EXEC mode, use the following commands to set the
operational mode to Simple and to configure the Port Aggregator features.
Command
configure
mode simple
enable
configure
port-aggregator group
{1–8}
284
Managing General System Settings
Purpose
Enter Global Configuration mode.
Select the SDM template to apply to the switch after the
next boot.
Exit to Privileged EXEC mode.
View information about the SDM template the switch is
currently using. Use the
parameters for the specified template.
Purpose
Enter Global Configuration mode.
Enable Simple mode. Switching modes clears the running
configuration. You are prompted to confirm that you want
to continue.
NOTE:
After the configuration clears, you are returned to
User EXEC mode if you are logged on through the console
port. If you are connected to the switch through Telnet or
SSH, the connection is terminated, and you must log on the
switch.
Enter Privileged EXEC mode.
Enter Global Configuration mode
Enter the Port Aggregator mode for the specified group to
configure aggregator group attributes.
template
variable to view the