Lag Hash Configuration - Dell M6220 User Configuration Manual

Adding a LAG Port to a Dynamic LAG by Using LACP
To add a dynamic LAG member:
1 Open the LAG Membership page.
2 Click in the LACP row to toggle the desired LAG port to L.
NOTE:
LACP.
3 Click Apply.
The LAG port is added as a dynamic LAG member to the selected LAG.

LAG Hash Configuration

Use the LAG hash algorithm to set the traffic distribution mode on the LAG.
You can set the hash type for each LAG.
To display the LAG Hash Configuration page, click Switching → Link
Aggregation → LAG Hash Configuration in the navigation panel.
Figure 28-6. LAG Hash Configuration
828
Configuring Link Aggregation
The port must be assigned to a LAG before it can be aggregated to an