Dell M6220 User Configuration Manual page 609

Command
configure
vlan protocol group
name
exit
show port protocol all
configure
vlan protocol group add
groupid
protocol
value
ethertype
protocol vlan group all
groupid
interface
interface
protocol vlan group
groupid
exit
vlan database
Purpose
Enter global configuration mode.
Create a new protocol group.
Exit to Privileged EXEC mode.
Obtain the group ID for the newly configured group.
Enter global configuration mode.
Add any EtherType protocol to the protocol-based VLAN
groups identified by
one protocol associated with it. Each interface and
protocol combination can be associated with one group
only. If adding a protocol to a group causes any conflicts
with interfaces currently associated with the group, this
command fails and the protocol is not added to the group.
groupid
• — The protocol-based VLAN group ID.
protocol
• — The protocol you want to add. The ethertype
can be any valid number in the range 0x0600-0xffff.
(Optional) Add all physical interfaces to the protocol-
based group identified by
interfaces to the protocol-based group as shown in the next
two commands.
groupid
— The protocol-based VLAN group ID.
Enter interface configuration mode for the specified
interface.
interface
— Specific interface type and number, such as
gi1/0/8.
Add the physical unit/port interface to the protocol-based
group identified by groupid.
groupid
— The protocol-based VLAN group ID.
Exit to global configuration mode.
Enter VLAN database mode.
groupid
. A group may have more than
groupid
. You can add individual
Configuring VLANs
609