Dell M6220 User Configuration Manual page 544

Command
(continued)
interface
interface
ip access-group
direction seqnum
544
Configuring Access Control Lists
Purpose
portvalue
•
the ACL rule is specified by the port value parameter
(Range: 0–65535).
portkey
•
one of the following keywords: domain, echo, ftp, ftpdata,
http, smtp, snmp, telnet, tftp, and www.
• log — Specifies that this rule is to be logged.
time-range-name
•
associate with the ACL rule.
• assign-queue
hardware queue for handling traffic that matches the
rule. (Range: 0-6)
• mirror
to be copied to the specified interface.
• redirect
matching this rule to be forwarded to the specified
interface.
(Optional) Enter interface configuration mode for the
specified interface. The
interface type and number, for example gigabitethernet
1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
name
Bind the specified ACL to an interface.
NOTE:
To apply this ACL to all interfaces, issue the command
in Global Configuration mode.
name
•
name up to 31 characters in length)
direction
•
Default is
seqnum
•
lower sequence number has higher precedence. Range: 1
– 4294967295. Default is1.
— The source layer 4 port match condition for
— Or you can specify the
— Specifies the named time range to
queue-id
— Specifies the particular
interface
— Allows the traffic matching this rule
interface
— This parameter allows the traffic
interface
— Access list name. (Range: Valid IP access-list
— Direction of the ACL. (Range: In or out.
in
.)
— Precedence for this interface and direction. A
portkey
, which can be
variable includes the