When Are L3 Multicast Features Required - Dell M6220 User Configuration Manual

Hide thumbs Also See for M6220:

Table of Contents

There are two configured learning modes of the MVR operation: dynamic and

In the dynamic mode MVR learns existent multicast groups by parsing the

IGMP queries from router on source ports and forwarding the IGMP joins

from the hosts to the router.

In the compatible mode MVR does not learn multicast groups, but they

have to be configured by administrator and protocol does not forward joins

from the hosts to the router. To work in this mode the IGMP router has to

be configured to transmit required multicast streams to the network with

the MVR switch.

Enabling MVR and IGMP on the Same Interface

MVR and IGMP snooping operate independently and can both be enabled on

an interface. When both MVR and IGMP snooping are enabled, MVR listens

to the IGMP join and report messages for static multicast group information,

and IGMP snooping manages dynamic multicast groups.

When Are L3 Multicast Features Required?

In addition to L2 multicast features, the switch suports IPv4 and IPv6

multicast features. You configure the IPv4/IPv6 multicast features if the

switch functions as a multicast router that can route multicast traffic between

VLAN routing interfaces. In this case, you must enable a multicast routing

protocol on the switch, such as PIM-SM. For information about L3 multicast

features, see "Managing IPv4 and IPv6 Multicast" on page 1177.

If the switch functions as a multicast router, it is possible to enable both

IGMP and IGMP snooping so that IGMP forwards multicast traffic for

directly connected hosts between VLANs, and IGMP snooping prevents the

multicast router from flooding incoming multicast packets on the ingress

Configuring L2 Multicast Features

M8024 M6348 M8024-k