Configuring And Viewing Mld Proxy - Dell M6220 User Configuration Manual

Command
show ipv6 mld interface [vlan
vlan-id
]
show ipv6 mld interface stats
vlan-id
[vlan ]
show ipv6 mld groups [interface
vlan-id
vlan ]
show ipv6 mld membership

Configuring and Viewing MLD Proxy

Beginning in Privileged EXEC mode, use the following commands to
configure the upstream VLAN routing interface as an MLD proxy. The MLD
proxy issues host messages on behalf of the hosts that have been discovered
on the downstream MLD-enabled interfaces. The upstream interface is the
interface closest to the root multicast router, which should be running IGMP .
NOTE:
Configure only the upstream interface as the MLD proxy. MLD should be
enabled on all downstream interfaces. IPv6 routing must be enabled on the
switch for the MLD proxy feature to operate.
Command
configure
vlan-id
interface vlan
ipv6 mld-proxy
ipv6 mld-proxy reset-status
ipv6 igmp-proxy unsolicit-rprt-
seconds
interval
CTRL + Z
1250
Managing IPv4 and IPv6 Multicast
Purpose
View MLD information for all interfaces or for
the specified interface.
View MLD statistics for all interfaces or for the
specified interface.
View the registered multicast groups on the
interface.
View the list of interfaces that have registered in
any multicast group.
Purpose
Enter global configuration mode.
Enter Interface Configuration mode for the
specified VLAN.
Configure the interface as an MLD proxy
interface.
(Optional) Reset the host interface status
parameters of the MLD Proxy.
Configure the unsolicited report interval for the
MLD proxy interface.
seconds
The range for
Exit to Privileged EXEC mode.
is 0–260 seconds.