Configuring And Viewing Dvmrp Information - Dell M6220 User Configuration Manual

Configuring and Viewing DVMRP Information

Beginning in Privileged EXEC mode, use the following commands to
configure DVMRP on the switch and on VLAN routing interfaces and to view
DVMRP information.
Command
configure
ip dvmrp
ip multicast
vlan-id
interface vlan
ip dvmrp
ip dvmrp metric
exit
show ip dvmrp interface
vlan-id
vlan ]
show ip dvmrp neighbor View neighbor information for DVMRP .
show ip dvmrp nexthop View the next hop information on outgoing interfaces for
show ip dvmrp prune
show ip dvmrp route
1260
Managing IPv4 and IPv6 Multicast
Purpose
Enter global configuration mode.
Enable DVMRP on the switch.
Enable IP multicast.
Enter Interface Configuration mode for the specified
VLAN routing interface.
Enable DVMRP on the interface.
metric
Configure the metric (range: 1–31) for an interface. This
value is used in the DVMRP messages as the cost to reach
this network.
Exit to Privileged EXEC mode.
View the multicast information for the specified interface.
routing multicast datagrams.
View the table that lists the router's upstream prune
information
View the multicast routing information for DVMRP .