Operating Specifications; Moving Or Rotating Parts; High Operating Temperatures; Connection Directions - KEB COMBIVERT S4 Instruction Manual

2. Operation
Specifications
2.1 Moving or Rotating
Parts
2.2 High Operating
Temperatures
°C
100
0
2.3 Connection
Directions
Operation Specifications
– Motor shaft
– Feed axis and parts connected to it
Prior to any work on the machine (e.g. exchange of
tools), disconnect the machine and secure against
unintended restart!
Safely secure movement range of machine during
operation! Danger of injury!
– Housing of servo motor
– Braking resistors
Motor housing and braking resistor can attain very high
operating temperatures! Danger of injury!
A trouble-free and safe operation of the servo system is only warranted
when the following connection instructions are observed.
When deviated from, malfunctions and damages may occur in
isolated cases.
– The servo controller KEB COMBIVERT S4 is only designed for a fixed
connection.
– Do not interchange power cable and motor line.
– Lay control and power lines separately (min. 10 cm distance).
– Connect control lines only to switching elements and setting devices
(relay, switch, potentiometer), that are suitable for extra-low voltages.
– Use shielded/twisted control lines. Connect the shield only single-
sided to PE of the servo controller.
GB
GB 5