KEB COMBIVERT S4 Instruction Manual page 78

Parameter Description
Switching Condition
Output D2
GB
Switching Conditions
Torque Level Output D1
Speed Level Output D2
GB 34
Defines the switching
condition of digital output D2.
! Refer to table below !
Digital output D1 and D2
Value Switching condition
0 always active
1 always active
2 system switched on; no abnormal operating condition
3 ready for operation and modulation enabled
4 abnormal operating condition / Fault (CP.2 = A.xxx or E.xxx)
5 inverter blocking after fault (E.xxx)
6 prewarning level electr. protective motor relay (OH.2) exceeded
7 after triggering of motor PTC-contact
8 prewarning level OH.2 or dOH exceeded
9 current controller in limitation
10 speed controller in limitation
11 any controller in limitation
12 drive in acceleration phase
13 drive in deceleration phase
14 drive runs with constant speed
15 drive runs with constant speed except speed 0
16 clockwise rotation – not at noP, LS, abnormal stopping or fault
17 anti-clockwise rotation-not at noP,LS,abnormal stopping or fault
only Digital output D1
18 actual speed > 0,1 x rated speed
19 apparent current > rated current
20 torque > torque level CP.23
only Digital output D2
18 actual speed > speed level CP.24
19 apparent current > rated current
20 torque > rated torque
21 Angle deviation > angle level
22 Reference mode completed
23 Target position reached only available in the posi mode
24 actual position > position level
25 Break control
Defines the torque level of
digital output D1.
Defines the speed level of
digital output D2.
Setting range:
Resolution:
Factory setting:
Remarks: ENTER–Parameter
Customer setting:
Setting range:
Resolution:
Factory setting:
Customer setting:
Setting range:
Resolution:
Factory setting:
Customer setting:
0...34
1
18
______
0...50 Nm
0,1 Nm
0,5 x M
Rated
______ Nm
0...16000 rpm
0,5 rpm
0,5 x n
Rated
______ rpm