Parameters - ABB PST Installation And Maintenance Manual

No Type Parameter
1 Read/Write Setting Ie
2 Read/Write Start Ramp
3 Read/Write Stop Ramp
4 Read/Write Init Volt
5 Read/Write End Volt
6 Read/Write Step Down
7 Read/Write Current Lim
8 Read/Write Kick Start
9 Read/Write Kick Level
10 Read/Write Kick Time
11 Read/Write Start Range
12 Read/Write Stop Range
13 Read/Write Overload
14 Read/Write OL Class
15 Read/Write OL Class S
16 Read/Write OL Class R
17 Read/Write OL Op
18 Read/Write Locked Rotor
19 Read/Write Lock R Lev
20 Read/Write Lock R Time
21 Read/Write Lock R Op
22 Read/Write Underload
23 Read/Write Underl Lev
24 Read/Write Underl Time
25 Read/Write Underl Op
26 Read/Write Phase Imb
27 Read/Write Ph Imb Lev
28 Read/Write Ph Imb Op
29 Read/Write High I
30 Read/Write High I Op
31 Read/Write Phase Rev
32 Read/Write Ph Rev Op
33 Read/Write PTC
Low Voltage Products & Systems
ABB Inc. • 888-385-1221 • www.abb-control.com
Chapter 8 - Fieldbus communication (option)

8:1.3.8 Parameters

Description
Setting current
Time for start ramp
Time for stop ramp
Initial voltage for start ramp
End voltage for stop ramp
Voltage value to which the softstarter
shall step down at stop and where it
shall commence the stop ramp.
Level of the current limit.
Selection of Kick start
Level of Kick start if selected
Time for Kick start if selected
Selectable range for start ramp
Selectable range for stop ramp
Overload protection
Overload Class
Overload Class, Dual type, Start Class 10A, 10, 20, 30
Overload Class, Dual type, Run Class 10A, 10, 20, 30
Type of operation for overload
protection
Locked rotor protection
Trip level for locked rotor protection
Trip time for locked rotor protection
Type of operation for locked rotor
protection
Underload protection
Trip level for Underload protection
Trip time for Underload protection
Type of operation for Underload
protection
Phase imbalance protection
Trip level for phase imbalance
protection
Type of operation for phase imbalance
protection
High current protection
Type of operation for high current
protection
Phase reversal protection
Type of operation for phase reversal
protection
PTC protection
Range
0 – 3000 (*)
1 – 120
0 – 120
30 – 70
30 – 70
30 – 100
2.0 – 5.0
No, Yes
50 – 100
0.1 – 1.5
1-30s, 1-120s
0-30s, 0-120s)
No, Normal, Dual
10A, 10, 20, 30
Stop– M, Stop– A, Ind
No, Yes
3.0 – 8.0
0.2 – 10.0
Stop– M, Stop– A, Ind
No, Yes
0.4 – 0.8
1 – 30
Stop– M, Stop– A, Ind
No, Yes
10 – 80
Stop– M, Stop– A, Ind
No, Yes
Stop– M, Stop– A, Ind
No, Yes
Stop– M, Stop– A, Ind
No, Yes
Unit
Amp
Sec
Sec
%
%
%
x Ie
%
Sec
x Ie
Sec
x Ie
Sec
%
109
AC 1006.9 - 5/03