Setup Gui - Events - Events - Preset Events - junger D*AP8 FLX Manual

Setup GUI – EVENTS – Events – Preset Events
A Preset Event is a group of presets you may load on one occasion to the On Air parameters of function
blocks. When executing such an event you may for example change the compressor and EQ settings, by
simply assigning the individual preset of your choice to the processing block or the system, to an interface,
to the routing, to the program path or even to the monitor output:
The Preset Events allow you to reconfigure the D*AP8 completely, partially or to change a few audio
parameters marginally.
You are also able to create a new preset event semi-automatically by pressing <create event>:
This picture shows an excerpt from the
Preset Events pane where a few
presets are pre-selected for the event:
"Loundess Limiter".
If no preset is selected you have a
dash in the drop down field. Some
function blocks (e.g. Monitor) even
have no preset assigned at all at the
moment so there is no drop down box.
Event name [New Event] default
A unique name to address this
preset event later in the action
manager.
.
Use Settings from [On Air / Existing Event / Empty]
"On Air" The events manager will copy
all
new presets
(that have been selected via the
"Include these Blocks"
check boxes).
"Existing Event" The presets of the selected event
will be copied to the new event and
may be tuned afterwards to form a
slightly different event.
90
D*AP8
Pull down list of all factory
default presets of the Level
Magic, Loudness Limiter being
one of them.
On Air parameters to
in all function blocks,