Table of Contents
Advertisement
D*AP8
Expert
Clear Processing History
Setup GUI – AUDIO PROCESSOR – Voice Over
The voice over section allows for manual (mixing) / automatic (ducking) of a voice channel over the
program feed. The dynamic schematic in the top of the pane shows the actual signal flow :
Mode
Signal Path
[ON / OFF]
This is a triggered action that resets the dynamic processing without
any release time. Imagine it as a short circuit to the timing circuits of
an analog dynamic processor which discharges the whole system and
immediately returns the dynamic gain to its neutral state. This function
is useful to reset the process when switching programs (e.g. from
movie to commercial breaks).
[OFF / Always ON / AUTO]
Defines the operating mode of the voice over block. AUTO will detect
the signal in the voice channel and will automatically perform the voice
over (ducking).
[Pre Leveler / Post Leveler]
See AUDIO PROCESSOR > Overview for the actual location of the
circuit in the signal path.
71
Advertisement
Table of Contents
