Setup Gui - Interfaces - 8 Ch Analog Interface; Setup Gui - Interfaces - 4 Ch Analog I/O Interface - junger D*AP8 FLX Manual

D*AP8
Setup GUI – INTERFACES – 8 Ch Analog Out Interface
Analog Output Calibration
(dBu) (level for digital 0 dBFS)
ANLx (dBu)
Setup GUI – INTERFACES – 4 Ch Analog I/O Interface
An additional analog interface can be installed in the Interface slot.
It provides 4 additional analog line inputs and outputs on a 25pin D-Sub connector:
Enable Relay Bypass
(All Channels)
Analog Input Calibration
(dBu)
(level for digital 0 dBFS)
Analog Output Calibration
(dBu)
(level for digital 0 dBFS)
sets the factor for D/A conversion
[0.0 ... 15.0 ... 24.0]
output level for output "x" at 0dBFS.
The default setting of 15.0dBu correlates to the 6dBu = -9dBFS
conversion.
[ON / OFF]
Power fail bypass relay that may be activated from the GUI
[0 ... 15.0 ... 24.0]
A/D conversion parameter. It defines the analog input level in dBu
to reach a digital full scale signal.
[0 ... 15.0 ... 24]
D/A conversion parameter. It defines the analog output level in dBu
for a digital full scale signal.
41