Table of Contents
Advertisement
D*AP8
Setup GUI – SYSTEM – System Status
The system status is a special link you can reach independently from where you are :
The System Status page provides a top level view of the various status information available for the device.
Device Status
Power 1
Power 2
Temperature
Sync Lock
NTP Server Status
Processing Status
Bypass
Interface Status
AES I/O
Interface 1 SDI I/O
Dolby Processing Status
Decoder (Slot A)
Encoder (Slot A)
Metadata
Coprocessor Status
provides the hardware status of the D*AP8 unit.
status of the first power supply (left hand side from rear).
status of second power supply (right hand side from rear).
measured on the surface of the main PCB.
turns red if the external sync source is removed or unstable.
Is green if the NTP server synchronization is turned off or the clock is
synchronized.
Turns red if the clock can not be synchronized by one of the NTP servers.
turns red if Bypass is activated.
turns red if an AES input that is internally in use (i.e. you have routed it to
an input of a function block) has detected an error.
turns red if the SDI input is not locked (not present or bad SDI signal).
turns orange if the input signal is not Dolby encoded (PCM).
status of the first D-E encoder (if license is installed).
status of the metadata.
turns red if the co-processor encounters a problem.
15
Advertisement
Table of Contents
